DU-HA DU-HOOKY User Manual (English)

To Next Page

DU-HOOKY

Assembly Instructions

Remove Du-Hooky from packaging and layout on a table or bench.

Attach the end tube with the yellow tip to the bent tube by depressing

the push button spring on the end tube and sliding it into the end of the

bent tube and line up with the hole in the bent tube until the push spring

button snaps into place. The end tube can be positioned in either direction

so the yellow tip can be positioned in either direction.

Next attach the bent tube to the re-tractable tube by depressing the push

button spring on the re-tractable tube and sliding the bent tube onto the

re-tractable tube, line up with hole in tube until the push spring button

snaps into place. The bent tube can also be positioned in either

direction, this is helpful when retrieving items and the re-tractable tube

keeps loosening. You can turn the end tube the opposite direction so it

stays tightened.

DU-HA, Inc. // www.du-ha.com

phone: 1.866.306.DUHA (3842) // fax: 1.218.998.4013 // 306 Saint Andrews Street South, Fergus Falls, MN 56537

PART #70099

Need help?

Do you have a question about the DU-HA DU-HOOKY and is the answer not in the manual?

DU-HA DU-HOOKY Specifications

General

Remove the Du-Hooky from packaging and place it on a table or bench for assembly.

Connect the end tube with the yellow tip to the bent tube using the spring button.

Connect the bent tube to the retractable tube using the spring button for secure attachment.

Attach the mounting clip to a convenient location in your vehicle or shop using a 5/16-inch socket.

Twist the shaft counterclockwise to extend and clockwise to tighten at the desired length.

Slide the tip under items and pull towards you to retrieve them from difficult spots.

Loosen the set screw to turn the tip to a desired position, then re-tighten.

Remove the end cap to access the threaded connector for attaching accessories.