Dualtron EY3 - Maintenance and Care

Maintenance and Care
Recommended Maintenance Schedule
WARNING
Sun exposure and extreme temperature conditions (overheating and supercooling) will accelerate the aging of plastic parts and may lead to a decrease in battery life.
For your riding safety, please be sure to maintain and check your scooter regularly. You are familiar with and understand the frequency, condition and place of use of
your scooter, and are responsible for regular inspection of your scooter. If any abnormality is found, please stop using it immediately and go to the authorized outlet
for inspection and maintenance in time. The following table is our recommended regular maintenance items and cycles.
Item Component
Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.
Tire pressure Inflate tires to 32–38 psi. Note: Remember to screw the valve cap after inflating!
Tire wear
Screws on the
stem top
Mainframe
maintenance
Check if the tires are cracked, deformed, or significantly worn.
Tighten the screws fixed with the handlebar and the stem.
The suggested torque is 6–8 N·m.
Tighten the screw on the throttle. The suggested torque is 4–4.5 N·m.
Tighten the screws on the brake levers. The suggested torque is 8.5±0.5 N·m.
Tighten the screws on the stem top. The suggested torque is 2.4 N·m.
Maintenance Method
Every 3
months
Every 6 months
or every 310
miles (500 km)
After 1 year or the
total mileage>1864
miles(3000km)
√ √ √
√ √ √
√ √ √
√ √
√ √
09