NOTE: If any grass residue is caught in the discharge chute, clean it using a
brush .Do not remove grass debris in the mower casing or On the blade by hand or with
your feet. Instead use suitable tools such as a brush or broom. To ensure that the cut
grass can be collected into grass Bag, the discharge opening and inside the mower
casing must be cleared of any blockage.
WARNING: Before performing any maintenance or cleaning work, switch
Off the engine and wait until the blade has come to a stop.
General cleaning
The lawn mower should be cleaned thoroughly every time after it has been used.
Always clean your lawn mower immediately after use.
Do not allow grass cuttings and other debris to become dry and hard on any of the mower
surfaces.
Dried grass remnants and dirt may impair the mowing operation.
Check that the grass chute is free of any residual grass. Remove any such residue. Check the
underside of the lawn mower and the blade mount .for this purpose, tilt the Lawn mower onto its
left side (opposite the oill filler neck)
NOTE: Before placing the lawn mower on its side, fully drain the fuel tank using
a petrol extraction pump.
Do not tilt the lawn mower by more than 90 degrees.
Maintenance of the spark plug.
As shown in Fig 19
1. Once the engine has cooled, pulI off the spark plug with a twist.
2. Remove the spark plug using a spark plug wrench
3. Clean the spark plug with a wire brush (not supplied).
4. Using a feeler gauge set thegap to 0.75mm
5. InstalI the spark plug carefully by hand, to avoid cross-threading.
6. After the spark plug is seated , tighten with the spanner to compress the washer.
To Next Page
Loading...
