Why is there smoke or odor during initial operation of my Duluth Forge Stove?
If you notice a slight smoke or odor during the initial operation of your Duluth Forge Stove, it's likely due to residues from the manufacturing process. This problem should stop after a few hours of operation.
Why is there a high yellow flame during burner combustion in my Duluth Forge FDSR25 Stove?
If your Duluth Forge Stove has a high yellow flame during burner combustion, it could be due to not enough air, a defective gas regulator, or inlet gas pressure that is too low. Check the burner for dirt and debris and clean it if necessary. Replace the gas regulator or contact your local gas supplier.
Why does my Duluth Forge Stove make a clicking/ticking noise after the burner is lit or shut off?
If your Duluth Forge Stove produces a clicking or ticking noise just after the burner is lit or shut off, it's likely due to metal expanding while heating or contracting while cooling. This is common with most heaters. If the noise is excessive, contact a qualified service technician.
Why is there white powder residue forming near my Duluth Forge Stove?
If you find white powder residue forming within the burner box or on adjacent walls or furniture when using your Duluth Forge Stove, it's likely due to vapors from furniture polish, wax, carpet cleaners, etc., turning into white powder residue when heated. Turn off the heater when using these products.
What to do if I smell gas during Duluth Forge FDSR25 combustion?
If you smell gas during combustion with your Duluth Forge Stove, there might be foreign matter between the control valve and burner, or there could be a gas leak. Take apart the gas tubing and remove any foreign matter. Locate and correct all leaks.
What to do if there is a spark but no ignition on my Duluth Forge FDSR25 Stove?
If, when you press the ignitor button, there's a spark at the ODS/pilot but no ignition on your Duluth Forge Stove, check if the gas supply is turned on and the equipment shutoff valve is open. Ensure the control knob is fully pressed in while pressing the ignitor button and that it is in the PILOT position. If it's a new installation or there was a recent gas interruption, continue holding down the control knob and repeat the igniting operation until the air is removed. Also, the ODS/pilot may be clogged, there may be incorrect inlet gas pressure, or the gas supply may be depleted (propane). Turn on the gas supply or open the equipment shutoff valve. Fully press in the control knob while pressing the ignitor button. Clean or replace the ODS/pilot assembly, check the inlet gas pressure, or...
Details on connecting the stove's 120V electrical power supply and remote receiver.
Mandatory minimum clearance distances to combustible materials for safe installation.
Instructions for selecting and connecting the correct gas type (Natural Gas or Propane/LP), including regulator setup.
Instructions for installing batteries and decorative logs for the stove.
Step-by-step guide for safely lighting the pilot and main burner of the stove.
Instructions for programming and operating the stove using the remote control system.
Procedures for cleaning the main burner, injector holder, and pilot air inlet holes.
Details on proper grounding of the stove's electrical system for safety.
Common issues with the ignitor, pilot light, and flame behavior, with corrective actions.
General| Heating Capacity | 25, 000 BTU |
|---|---|
| BTU Output | 25, 000 BTU |
| Vent Type | Vent-free |
| Oxygen Depletion Sensor (ODS) | Yes |
| Material | Steel |
| Color | Black |
| EPA Certified | No |
| Fuel Type | Natural Gas |
| Heating Area | 1, 000 sq ft |
| Ignition Type | Piezo |
| Log Length | 18" |
| Efficiency | 99.9% efficient |
To Next Page
