Dulytek DHP7 - Operating Instructions; Preparing the Heat Press

GETTINGFAMILIAR(continued)
INSTRUCTION MANUAL: DHP7 PAGE 7
Dulytek Equipment
www.dulytek.com Email: help@dulytek.com
© 2018 Dulytek
All rights reserved
DHP7 PRESS
FEATURES AND
CONTROLS -
BACK
OPERATING INSTRUCTIONS
PREPARING
PRESS
1. Makesurethepressstandsonaatsturdycountertop.
2. Make sure all switches and controls are turned OFF.
3. Prepare materials you wish to press.
4. Close the release valve by turning the knob clockwise until it is tightly
closed.
5. Insert the pump handle into the pump handle socket .
6. Insert the included AC power cord into the press AC power cord socket
andthenplugitsotherendintoanelectricaloutlet(110V).
J
.
.
I
J
AC Power Cord
Socket
ON / OFF Switch
F G
H