2
3
0
1
0
1
USING THE SCREW-DOWN
CROWN
Do NOT pull the crown unless it is
UNSCREWED first:
NOTE: Failure to SECURELY screw down the
crown after setting the watch may affect its
water resistance.
TO UNSCREW: Turn the
crown anti-clockwise until it
turns freely without tension.
GENTLY pull the crown out
to the other desired
positions for watch setting
(see specific operating
instructions on the
following pages).
TO SCREW: Push the crown
ALL THE WAY IN (towards
the watch) THEN begin to
turn clockwise until it is
securely screwed down.
Before you use this watch,
It is recommended that you manually
wind the mainspring to start it
moving.
THIS WATCH IS AN AUTOMATIC WATCH
EQUIPPED WITH A MANUAL WINDING
MECHANISM.
WINDING THE MAINSPRING
1. Unscrew the crown by turning
it anti-clockwise.
2. When it is in position [1], turn
the crown clockwise to wind.
Wind 15-20 times and it will
start to move naturally after
shaking slightly.
3. Push the crown in then screw
it securely.
To Next Page
Loading...