5427 hollister avenue, santa barbara, ca 93111
Tel. 805.964.9610 Fax. 805.964.9749
www.seymourduncan.com
Wiring Diagram for
All Seymour Duncan
Humbucker Pickup Models
Basic Installation:
1. Remove the strings from your guitar.
2. Remove the back plate and flip it over.
3. De-solder the original pickup’s wires from the controls. Be sure to remember where
they were connected. A photo or sketch may help.
4. Remove the original pickup from the pickup cavity.
5. Put the Seymour Duncan pickup into the pickup cavity.
6. Tin the wires from the Seymour Duncan pickup, and then solder them into place.
7. Replace the back plate.
8. Restring your guitar.
9. Adjust the pickup height. Your pickup should be between 1/8” and 1/16” from
the strings when the strings are pressed down at the highest fret.
Congra tulations on y our pur chase of a fine , han d-built, Seymour Duncan electric guitar pickup .
Installing this pickup isn ’ t complicat ed. If you ’re handy with tools , it will be a simple and fun project. But
if you hav e no experience handling red-hot soldering irons , we rec ommend having a qualified guitar
tech install your pickup.
Visit seymourduncan.com for additional wiring diagrams.
To Next Page
Need help?
General
