To Next PageTo Next Page
Need help?Do you have a question about the dunkermotoren BG 45x30 SI and is the answer not in the manual?
General| Type | Brushless DC Motor |
|---|---|
| Protection Class | IP40 |
| Rated Speed | 3000 rpm |
| Rated Torque | 0.095 Nm |
| Stall Torque | 0.28 Nm |
| Stall Current | 4.5 A |
| Terminal Resistance | 5.3 Ω |
| Terminal Inductance | 1.8 mH |
| Torque Constant | 0.062 Nm/A |
| Speed Constant | 154 rpm/V |
| No-load speed | 4000 rpm |
| No-load current | 0.15 A |
| Nominal speed | 3000 rpm |
| Nominal torque | 0.095 Nm |
| Nominal current | 1.6 A |
Read and observe warnings to protect from danger and avoid device damage.
Essential safety instructions for operation, installation, and qualified personnel.
Detailed electrical and performance specifications for BG 45x15 SI and BG 45x30 SI motor variants.
Details on power stage shutdown if temperature exceeds 105°C and confirmation criteria.
Logic supply voltage monitoring for power stage shutdown below 8.5V, with confirmation at 9V.
Power supply voltage monitoring for shutdown below 5V (1 sec), with confirmation at 6V.
Logic supply voltage monitoring for shutdown above 35V, with confirmation below 34V.
Power stage supply voltage monitoring for shutdown above 33V/58V (1 sec), confirmation below 32V/57V.
I2t protection function monitors and limits motor current to prevent damage.
Using the SI-Configurator software to adapt and store motor parameters and functions.
Information on the drive's maintenance-free design and procedures for taking it out of service and disposal.
