DUOTTS N26 - In St al Lat Ion of Integral Bo Dy

`
屯
`
`
`
P
1. Adjust the Stem to the
front
and lock the screws
with an Allen key. Use an
Allen key to remove 4 bolts.
4. Place the gasket as
shown in the picture with
the raised side facing
outwards.
7. Install the front fork clip
and tighten the screws,
then tighten the screws
with a wrench.
\
2. Attach the handlebar to
the stem connection,
and
th read in the bolts.
5. Place the spacer with
the protrusion along the
direction of the front fork,
and then align the front
fork with the motor shaft.
至，
8. Inflate the front wheel
slowly to prevent the tire
from bulging
out on both
sides.
3. Remove the front wheel
clip, then remove the
front fork protection
rod
and brake protection pad.
_lI
6. Note: Align the disc
with the brake.
9. Install front fenders and
head lights.
06