Table of Contents
Machinery
1. Description of Mechanisms ............................. 7
1-1. Feed Plate Up/Down Device mechanism .. 7
1-2. Paper Feed Mechanism............................. 8
1-3. Feed Drive Mechanism .............................. 8
1-4. Conveyance Mechanism............................ 9
1-5. Paper Receiving Mechanism .................... 10
1-6. Conveyance Switch Mechanism ............... 11
2. Adjusting Sections .........................................11
2-1. Adjusting the Switch Solenoid................... 11
2-2. Adjusting the Conveyance Cover.............. 12
2-3. Adjusting the Tension of the Timing Belt .. 13
3. Replacing the Parts........................................14
3-1. Replacing the Feed Rubber Ring.............. 14
3-2. Replacing the Paper Separator................. 14
3-3. Replacing the Electromagnetic Clutch ...... 15
3-4. Replacing the magnet Proximity sensor ... 16
Electricity
1. Construction Block Layout ............................. 19
2. Outline of Each Block.....................................20
3. Test Mode and Checking the Motion .............25
3-1. Setting the test Mode ................................ 25
3-2. Checking Motions .....................................25
4. Using the bit Switches....................................28
5. Trouble Shooting............................................31
6. MAIN SHEMATIC DIAGRAM (DC-6) ............. 33
7. OVERALL SHEMATIC DIAGRAM (DC-6) ..... 34
8. COMPONENT WIRING (DC-6) ..................... 35
To Next Page
Loading...
