PROBLEM POSSIBLE CAUSE REMEDY
Machine is not heating. A. Out of water (light may not be on yet)
B. Wrong setting used.
A. Add water.
B. Turn to
setting.
Pressure is dropping during operation. A. Pressure set to max for too long. A. Use lower pressure setting.
The electrical cord is damaged. A. Replace power cord.
A. Contact Dupray at 1-800-881-3990 (USA
& Canada) or 01-800-877-0180 (Mexico)
for replacement.
The hose keeps falling o from the
connection outlet.
A. The hose is not properly
connected.
A. Make sure you push the hose in all the way
and ensure the locking pin is in place.
The white lever on the rectangular or
triangular tool cannot change position.
A. The arrow on the connector and the dot
on the tool are not lined up.
A. Rotate the connector so that the arrow
on the connector and the dot on the tool
line up. Move the white lever to the cor
-
rect position (assembly, lock, or rotate).
20
To Next Page
Loading...
