Dura Heat DH2304 User Manual (English)

Questions and Answers:

D
Debra RodriguezJul 26, 2025
Why won't my Dura Heat Gas Heater light?
- M
  Misty BowersJul 26, 2025
  Your Dura Heat Gas Heater might not light due to several reasons: the fuel tank could be empty (fill it with water-clear 1-K kerosene), there might be water in the kerosene (drain the tank, replace the wick, and refill with clean kerosene), the igniter plug may not be glowing (replace the batteries, replace the igniter plug, and check for broken wires), or the igniter plug is touching the side of the wick (lower the wick until the igniter plug contacts the top).
T
Tony SanchezJul 30, 2025
How to stop my Dura Heat DH2304 Gas Heater from producing smoke or odor?
- M
  Matthew CollinsJul 30, 2025
  If your Dura Heat Gas Heater is producing smoke or odor, it could be due to several reasons. The flame might be too high (lower the wick to a 1/2” flame using the wick adjuster knob). The heater could be in an air draft (move it out of the draft). The burner might not be level (rotate the burner until it seats properly over the wick). There might be carbon or tar buildup on the wick (perform the "Carbon Removal / Dry Burning" procedure, replacing the wick if necessary). Finally, the kerosene could be contaminated (drain the tank, replace the wick, and refill with water-clear 1-K kerosene).
D
Dr. Jeremy SmithAug 3, 2025
What to do if the flame flickers or dies on my Dura Heat DH2304 Gas Heater?
- J
  Joanna YoungAug 3, 2025
  If the flame on your Dura Heat Gas Heater flickers or dies, it could be due to water in the kerosene (drain the tank, replace the wick, and refill with water-clear 1-K kerosene) or carbon/tar buildup on the wick (perform the "Carbon Removal / Dry Burning" procedure, replacing the wick if necessary).
H
Heather JonesAug 7, 2025
Why is the wick on my Dura Heat Gas Heater burning down excessively?
- J
  justinolsonAug 7, 2025
  If the wick on your Dura Heat Gas Heater is burning down excessively, it's likely due to dangerous, volatile fuel mixed with the kerosene, such as gasoline, benzene, alcohol, white gas, paint thinner, camp stove fuel, or oil compound. You should drain and clean the tank, remove and replace the wick, and fill the tank with water-clear 1-K kerosene.
L
Laura BennettAug 12, 2025
How to fix a Dura Heat Gas Heater wick adjuster that sticks?
- B
  Brent McdonaldAug 12, 2025
  If the wick adjuster on your Dura Heat Gas Heater sticks, it could be due to water present in the kerosene (drain the tank, replace the wick, and refill with water-clear 1-K kerosene) or carbon/tar buildup (perform the "Carbon Removal / Dry Burning" procedure, replacing the wick if necessary).
A
angela64Aug 16, 2025
What to do if the wick will not raise on my Dura Heat Gas Heater?
- O
  osbornerhondaAug 16, 2025
  To raise the wick on your Dura Heat Gas Heater, push the safety reset lever to engage the automatic safety shut-off device, then dial the wick up using the wick adjuster knob.
M
Michael ScottAug 20, 2025
What to do if my Dura Heat Gas Heater is enveloped in flames?
- C
  Clarence EnglishAug 20, 2025
  In the event your Dura Heat Gas Heater is enveloped in flames, call the Fire Department. Smother the flames with a fire extinguisher or sand. Alternatively, smother the flames with blankets and then throw water on the blankets. Do not throw water directly on the heater itself.