DURABLE 5087 - Core Mounting and Operation; Attaching Monitor Arm and Brackets

EN

English
Fixing the monitor arm on the table column
▶siehe Abbildung6
– Insert the arm bracket (4) in the table column (5) from top. Gui-
de the slot nut (11) of the arm bracket into the groove of the
table column.
– Fix the arm bracket (4) at the desired height using the adjusting
screw (12).
Fixing the brackets
▶siehe Abbildung7
– Slide the monitor bracket (2) or tablet bracket (19) right and left
over the monitor arm (3).
– Fix the position of brackets using the respective adjusting screw
(13).
Note:
Ensure that the brackets are fixed on the monitor arm
such that the adjusting screws are at the bottom.
▶siehe Abbildung8
– Place the cap (17) on the table column and end caps (18) on the
monitor arm.
Monitor mount
▶siehe Abbildung9
– Lay the monitor on a flat surface with the display facing down-
wards. Place a cover or similar under it for protection.
– Remove any coverings in the mount area of the VESA plate (1)
on the monitor. Consult the monitor manufacturer’s operating
instructions.
– Fasten the VESA plate (1) to the monitor with the enclosed
screws(20). Make sure that the plate is properly located. The
clamps must show the upper edge of the monitor.
– Insert the enclosed covering cap(21).