Version 20190806 Page
INSTALLATION & OPERATING INSTRUCTIONS
( Model: TR2003, TR2004 ; Transmitter: T1003, T1004 + Receiver: RR12)
IF YOU CAN NOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS, DO NOT ATTEMPT TO INSTALL OR OPERATE.
INTRODUCTION
This Durablow remote control system is to provide a safe and reliable control for gas heating appliances, such as fire
fireplace. The system can be operated thermostatically or manually from the transmitter (remote handset). The system
operates on radio frequencies (RF) within a 20-foot range and non-directional signals. The remote receiver box code
must be matched to the transmitter prior to initial use (see LEARNING TRANSMITTER TO RECEIVER).
Read ALL sections and original manufacturer manual for safety installation before any action. These safety features shut
down the system and appliance, such as fireplace when a potentially unsafe condition exists, such as high-heat.
PACKING LIST:
Please check and make sure all parts are in good condition before installation. Any questions, please do NOT return to
dealer, but email us (info@payandpack.com) and contact us on PayandPack.com immediately, we will provide solutions
shortly. Thank you.
1. Remote transmitter T1003 or T1004 (1),
2. Remote control receiver box RR12 with two signal wires (1),
3. USB power cord + adapter (1),
4. Wall mount cover plate (1), Switch box screw (2), Slide switch button (1)
5. Installation Instructions (1)
Fig. 1 Transmitter Handset
Fig. 2 LCD display on transmitter
To Next Page
Need help?
General
