INSTALLATION & OPERATING INSTRUCTIONS
( Model: TR1001 ; Transmitter: T1001 + Receiver: RR02)
IF YOU CAN NOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS, DO NOT ATTEMPT TO INSTALL OR OPERATE.
INTRODUCTION
This Durablow remote control system is to provide a safe and reliable control for gas heating appliances, such as fire
fireplace. The system can be operated manually from the transmitter (remote handset). The system operates on radio
frequencies (RF) within a 20-foot range and non-directional signals. The remote receiver box code must be matched
to the transmitter prior to initial use (see LEARNING TRANSMITTER TO RECEIVER).
Read ALL sections and original manufacturer manual for safety installation before any action. These safety features shut
down the system and appliance, such as fireplace when a potentially unsafe condition exists, such as high-heat.
PACKING LIST :
Please check (Fig. 1) and make sure all parts are in good condition before installation. Any questions, please email us
(info@payandpack.com) immediately before returning items or further actions, we will do our best to solve problems.
Thank you.
1. 2-botton remote transmitter (1), Remote receiver box w/ 18” wire (1)
2. Wall mount cover plate (1), Switch box screw (2), Slide switch button (1)
3. Installation Instructions (1)
To Next Page
General