SPECIFICATION
- Wingspan:1100mm (43.3in)
- Length: 930mm (35.4in)
- Flying Weight:1460g (52oz)
- Controls: 7 Channel (Ail, Ele, Thro, Rud, Flap, Gear, Airbrake)
- Motor: Aerostar 3536 750Kv brushless outrunner.
- Prop: 10x6 3-Blade
- ESC: Aerostar 40amp
- Battery: 4S 14.8V 25C 2200mah 4S
- Channels: 7 Channel Tx and Rx
INTRODUCTION
Thank you for purchasing the Durafly T-28 Trojan. This airplane was built based on the original
North American Aviation T-28 Trojan.
With the Durafly T-28 Trojan you can now experience what made this great model a classic. From
the perfectly captured outline to the super scale details. The T-28 Trojan uses environmentally safe
water-based paint, with retractable landing gear, LED Navigational Lighting sytem, under fuselage
air brake, and even the stickers are 100% the same as the original. Like all other Durafly models,
the T-28 Trojan also has all electronics pre-installed, all major components assembled for you, and
a full compliment of tools and accessories included. No glue is provided, since none is needed! The
T-28 Trojan screws together in just 6 easy steps, with multiple hatches allowing easy access to
internal electronics. We went one step further and included a wooden camera holder allowing you
to install your FPV equipment and experience the thrill of flying your T-28 Trojan in a whole different
way!
The Durafly T-28 Trojan, you deserve to have one.
1
To Next Page
Loading...
