Need help?Do you have a question about the Durafly Messerschmitt BF.109E-4 and is the answer not in the manual?
Lists all included components and parts for the Durafly Bf-109e model.
Prepares foam hinges by flexing them to reduce servo strain before assembly.
Installs carbon tail spar and tail pieces using screws and glue for alignment.
Connects elevator push rod to control horn and adjusts for neutral surfaces.
Secures the wing to the fuselage, ensuring servo wires pass through correctly.
Installs the spinner back plate, propeller, and spinner onto the motor shaft.
Glues under-wing radiators, pilot tube, cannons, exhaust stacks, and aerial into place.
Secures the bomb to the rack and installs the bomb rack assembly with the servo lead.
Centers servos and ensures all control surfaces are level after connecting the flight battery.
Verifies that control surfaces move in the correct direction with corresponding stick inputs.
Sets recommended throws for elevator and rudder for optimal handling and performance.
Configures aileron throws (low/high rates) and flap stages (up, mid, full).
Sets the COG and recommends suitable LiPo batteries for flight.
Explains the mix of vinyl and sticker decals and initial preparation steps.
Details the process for applying vinyl decals using front cover film and ensuring adhesion.
Covers applying sticker decals, handling bubbles, and sealing with an iron.
Lists specific spare parts for the Battle of Britain color scheme.
Lists specific spare parts for the desert color scheme.
General| Wingspan | 1100mm |
|---|---|
| Material | EPO Foam |
| Skill Level | Intermediate |
| Retracts | Yes |
| Weight | 1100g |
| Servos | 9g |
| Battery | 4S 2200mAh LiPo |
| Control | 4 Channel (Aileron, Elevator, Rudder, Throttle) |
| Motor | 3648-770KV Brushless Outrunner |
To Next Page