9-54 Driving and Operating
Programmable
Parameters
Factory Setting Minimum Value Maximum Value
Wheel Speed Sensitivity HIGH LOW, MEDIUM, HIGH
Remote Set Switch
Transition to Low
Voltage (<1.66 V)
SET_SPEED 1 STANDBY SPEED, SET SPEED_1 or SET SPEED_2
Remote Set Switch
Transition to Open State
(>1.66 V, <3.33 V)
PTO_STANDBY STANDBY SPEED, SET SPEED_1 or SET SPEED_2
Remote Set Switch
Transition to High
Voltage (>3.33 V)
SET_SPEED 2 STANDBY SPEED, SET SPEED_1 or SET SPEED_2
If the PTO factory preset
parameters do not match the
settings described above, then they
may have already been altered in
order to satisfy the requirements of
the installed PTO system and body
equipment.
See www.gmupfitter.com more
information on the installation of
wiring and programming for PTO
aftermarket equipment.
To Next Page
Loading...