4
Charging System
• Select CHARGING TEST: with the engine running the tester displays the following:
Review Data
• Select REVIEW DATA: the tool displays all the test results:
Print Data (Windows only)
• Select PRINT DATA: the tool displays all the test results:
Charging Test
Loaded Testing
Charging Test
Testing
- - -
Increase RPM to
2500 for 10s
Press ENTER to
continue
Charging Test
Load ed 14.16V
Unloaded 14.39V
Replace OK
Charging Normal
Charging Test
Load ed 14.16V
Unloaded 13.39V
Replace OK
Low
Charging Test
Load ed 14.16V
Unloaded 15.39V
Replace OK
High
Charging Test
Load ed 12.18V
Unloaded 12.18V
Replace OK
No Output
Good
Fault
Health:96% 490CCA
Charge:98% 12.64V
Internal R=6.1mΩ
Rated: 500A
GOOD BATTERY
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL
& ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical &
Electronics Equipment (WEEE). Any WEEE marked products must not be mixed with general
household waste, but kept separate for the treatment, recovery and recycling of the materials
used. Contact your local authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
• Connect the tool to the computer via USB cable.
• If the PC doesn’t automatically load the USB driver and recognise the tester, a USB
driver is included on the CD.
• Print software is also included to display the data from the tester and print to any
printer connected to the PC.
• Clear any previous data stored in the printer queue then connect the tester and the
data held in the tester will be displayed.
• Click on Print to send to the printer.
To Previous Page
Loading...