INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
■
■
■
■
■
Tape measure
■
Small, flat-blade screwdriver
■
#2 and #3 Phillips screwdriver
■
Level
Wrench or pliers
Pipe wrench
Scissors or cutting pliers
(to remove tie-downs)
Noncorrosive leak-detection
solution
Location Requirements
WARNING
Parts Supplied
■
■
■
Gas pressure regulator/hose assembly set for 11” WCP LP
gas.
1-“A
” size alkaline batter
Hardware packet
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use
grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for outdoor grills:
■
■
A minimum of 24” (58.0 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
A 24” (58.0 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
*See “Assistance or Service” section to order.
5
Screws:W 3/32-32*2/5" 4pcs used to install the door
To Next Page
Loading...
