1English1
English -8
Fig. 3
REMOVING SOCKETS
1. Always follow the procedure below to remove a socket. Pull out the socket from
the anvil of output drive directly. (see Fig. 3)
Always set lock button (4) to off position when installing and
removing socket or prevent the switch on when place the
wrench on bag, work table, tool cabinet…..etc.
FORWARD / REVERSE LEVER
The tool is equipped with a forward/reverse lever (see Fig. 4A), which was designed to
change rotation of the output drive.
1. For forward rotation, turn the lever counter-clockwise to the “F” position.
2. For reverse rotation, turn the lever clockwise to the “R” position.
Clockwise
Counterclockwise
(output drive pointed away from you)
Fig. 4
CAUTION
A
To Next Page
Loading...
