Page 18 of 43
3.6.7 ECO stop
Set the ECO stop if you wish for the stove to completely switch off as soon as the
desired temperature has been reached. Be aware that this may have consequences
for the life of your glow plug. In addition, and for ECO stop in particular, it is important
that you regularly check the combustion pot for contamination to ensure that the stove
starts up properly.
Set the ECO stop as follows: Simultaneously press SET and the power minus
for more than 5 seconds until PARAMETERS appears on the screen. Press SET
twice until it says ‘Parameter 1 Value (..)’.
Use the power button plus to navigate to parameter 62.
As a default, this value is set to 0, meaning that the ECO stop is deactivated. This is
where you set the temperatures at which the stove should switch.
For example: If you set this value to 2 and set the desired temperature (see Ti 3.4.2)
to 20°C, the stove will switch off at 22°C and on at 18°C. Set a large value to prevent
the stove from switching on and off continuously.
You can set the value using the temperature buttons.
Confirm the set value using SET
To Next Page
Loading...