Page 4 of 43
4.2.1 Batavia T3 21
4.2.2 Rembrand T2 / Carré 22
4.2.3 Pelle / Rinus 22
5 Problems and solutions 23
No image 23
No pellet supply 23
No ignition 23
The pellet stove becomes too hot 24
It’s becoming too hot in the house 24
6 Fault reports and solutions 25
6.1.1 ERROR 1 25
6.1.2 ERROR 5 25
6.1.3 ERROR 6 25
6.1.4 ERROR 8 25
6.1.5 ERROR 9 25
6.1.6 ‘Service’ 25
7 Components 26
Explanation of the components 26
7.1.1 Printed circuit board 26
7.1.2 Control panel 26
7.1.3 Data cable 26
7.1.4 Screw conveyor motor 26
7.1.5 Screw conveyor 26
7.1.6 Pressure monitoring device 26
7.1.7 Maximum thermostat 26
7.1.8 Glow plug 26
7.1.9 Blower 26
7.1.10 Convection fan 26
7.1.11 Encoder 27
7.1.12 Flue gas temperature sensor 27
7.1.13 Room temperature sensor 27
8 Reset component test / service message 27
8.1.1 Testing the screw conveyor motor 27
8.1.2 Testing the blower 27
8.1.3 Testing the convection fan 27
8.1.4 Testing the glow plug 27
8.1.5 Reading temperature sensors 27
8.1.6 Reading and resetting operating hours 28
8.1.7 Reading the fire cycle 28
9 Technical specifications 29
10 Electrical diagram 32
11 Combustion cycles 33
To Next Page
Loading...