DUROMAX XP WP Series - User Manual

Questions and Answers

J
John RamirezAug 11, 2025
How to start a DUROMAX Water Pump engine that won't start?
- C
  Christopher DrakeAug 11, 2025
  If your DUROMAX Water Pump engine won't start, first ensure the engine switch and fuel valve are set to “ON”. Check if the choke is closed. Make sure the fuel tank isn't empty and the fuel isn't old or contaminated; if it is, add fresh fuel. Inspect the spark plug; clean it if dirty, or replace it if broken. Confirm the engine is on a level surface. Finally, check the oil level and add or change the oil if needed.
S
stephenyangAug 26, 2025
How to troubleshoot a DUROMAX Water Pump engine that won't start?
- A
  Andrew LandryAug 26, 2025
  If your DUROMAX Water Pump engine won't start, make sure there is enough fuel, the fuel tap is turned on, and fuel has reached the carburetor. Also, check if the engine switch is in the ON position and that there's enough oil in the crankcase. Finally, verify the spark plug is generating sparks. If it still doesn't start, consult an authorized dealer.
O
olsentimothySep 2, 2025
What to do if my DUROMAX Water Pump is unable to suck up water?
- K
  Kimberly CarpenterSep 2, 2025
  If your DUROMAX Water Pump isn't sucking up water, check if it's filled with enough water and if the filter is clogged. Ensure the hose fastener clip is tightened and the hose isn't damaged. Also, verify that the suction head isn't too high. If it still doesn't work, consult an authorized dealer.
W
willie43Sep 10, 2025
Why does my DUROMAX Water Pump engine start, but shuts off after running for a short time?
- A
  Albert JenkinsSep 12, 2025
  If your DUROMAX Water Pump engine starts but shuts off quickly, it might be due to a low oil level; add or change the oil. Old or contaminated fuel can also cause this issue, so replace the fuel. If the engine is on an incline exceeding 15°, disconnect the low oil sensor.