Duronic DM553 User Manual

11
2.8-5kgs/6-11lbs
Load
15” - 27” 75x75, 100x100
VESA
-90°/+85°
Tilt
180°
Swivel
Rotate
360°
Max weight 11 lbs-5kg
CAUTION: DO NOT EXCEED
MAXIMUM LISTED WEIGHT
CAPACITY.SERIOUS INJURY
OR PROPERTY DAMAGE MAY
OCCUR!
Note:This product will need tension adjustments once installation is complete,Make sure all
equipment is properly installed on the product before attempting tension adjustments.
Any time equipment is added or removed from this product,resulting in a change in the weight
of the mounted load,you should repeat these adjustment steps to ensure safe and optimum
operation.Adjustments should move smoothly and easily through the full range of motion and
stay where you set it.If adjustments are dicult and do not stay in the desired position,follow
the instructions to loosen or tighten the tension to create a smooth,easy adjustment motion.
Nota:Una vez instalado,este producto necesita ajustes de tensión.Antes de realizar los ajustes de
tensión,cerciórese de que todo el equipo está bien instalado en el producto.Cada vez que se ag-
regue o quite equipo de este producto y cambie el peso de la carga montada,deberá repetir estos
ajustes para garantizar un funcionamiento seguro
-
-
-
-
EN-INSTRUCTION MANUAL
ES-MANUAL DE INSTRUCCIONES
FR-MANUEL D’INSTRUCTIONS
DE-BENUTZERHANDBUCH
IT -MANUALE DI ISTRUZIONI
Product A Product B
OR
DM553

Duronic DM553 Specifications

General

Brand	Duronic
Model	DM553
Category	Racks & Stands
Language	English

Summary

Important Setup Information and Safety

Tension Adjustment Guidance

Steps for adjusting product tension for smooth operation and safe load holding.

General Safety Disclaimer and Warnings

Critical warnings about potential injury, property damage, and warranty voiding if instructions are not followed.

Desktop Mounting Best Practices

Visual guidance on correct versus incorrect methods for mounting the product to a desktop.

Product Overview and Requirements

Product Line Graphs and Dimensions

Diagrams illustrating product dimensions, reach, and articulation ranges for models A and B.

Required Tools Not Included

List of tools necessary for installation that are not provided with the product.

Installing Product B

Product B Installation Step 1

Initial assembly step for Product B, involving screw removal from the spring arm.

Product B Installation Step 2

Second assembly step for Product B, showing bracket and clamp attachment options.

Installing Product A

Product A Installation Steps 1 & 2

First two installation steps for Product A, focusing on desktop clamp and arm attachment.

Product A Installation Steps 7 & 8

Later installation steps for Product A, showing monitor attachment to the arms.

Product A Installation Steps 3, 4, 5, 6

Middle installation steps for Product A, covering arm assembly and monitor plate attachment.