Duronic STM11 - Troubleshooting

15
Troubleshooting
3UREOHP 3RVVLEOH&DXVHDQG6ROXWLRQ
7KHPRSZRQ¶WVWDUW
Check the mains power outlet, the fuse
on the plug and if the switch is pressed
on or off.
There is no steam coming out
Check if the steam holes were
blocked. If they are, clean the blocked
holes with a damp cloth.
There is a lot of moisture after use
The mop pad is either too wet or
installed incorrectly. Remove it, wring
it out and place it back onto the mop
head ensuring all hook & loop pads
are attached together.
,WLVGLI¿FXOWWRPRYHZKLOVWLQXVH
The mop pad may be too dirty.
Wash and wring out the pad before
continuing to use it.
Alternatively
,
change the mop pad for a new one.
The mop pad is too dry. Allow the
steam to pass through it for a short
while to dampen it before attempting to
use it again.