Why is my Duronic STM11 Steam Cleaner difficult to move?
If your Duronic Steam Cleaner is hard to move during use, the mop pad might be too dirty or too dry. Try washing and wringing out the pad or replacing it with a new one. If it's too dry, let steam pass through it briefly to dampen it before using it again.
How to fix Duronic Steam Cleaner that won't start?
If your Duronic Steam Cleaner isn't starting, check the mains power outlet, the fuse on the plug, and ensure the switch is turned on.
What to do if there is no steam coming out of my Duronic STM11?
If no steam is coming out of your Duronic Steam Cleaner, the steam holes might be blocked. Inspect the holes and clean them with a damp cloth to remove any blockages.
Why is there a lot of moisture after using my Duronic STM11 Steam Cleaner?
If there is a lot of moisture after using your Duronic Steam Cleaner, the mop pad may be too wet or not correctly installed. Remove the pad, wring out excess water, and reattach it to the mop head, making sure all hook & loop pads are securely fastened.
Lists and illustrates the main parts of the steam mop for identification.
Step-by-step instructions for assembling the steam mop parts correctly.
Instructions on how to wash and care for the mop pads for reuse.
Guidance on how to properly store the steam mop when not in use.
General| Brand | Duronic |
|---|---|
| Model | STM11 |
| Category | Steam Cleaner |
| Language | English |
To Next Page