Usage
11 Disinfection and cleaning
NOTICE
Device malfunctions or damage due
to use of incorrect media
Guarantee claims may become invalid
as a result.
❯
Do not use any foaming agents such
as household cleaning agents or
instrument disinfectants.
❯
Do not use abrasive cleaners.
❯
Do not use agents containing chlorine.
❯
Do not use any solvents like acetone.
Dürr Dental recommends
– For disinfection and cleaning:
Orotol plus or Orotol ultra
– For cleaning:
MD 555 cleaner
Only these products have been tested by Dürr
Dental.
When using prophy powders, Dürr Dental recom-
mends the water-soluble Lunos prophy powders
in order to protect the Dürr Dental suction sys-
tems.
11.1 After every treatment
❯
Aspirate a glass of cold water through the large
and the small suction hoses. Do this even if
only the small suction hose was actually used
during treatment.
Suction through the large suction hose
causes a large amount of air to be drawn
up, thereby considerably increasing the
cleaning effect.
11.2 Daily after the end of treat-
ment
After higher workloads before the midday
break and in the evening
The following are required for disinfection/clean-
ing:
ü
Non-foaming disinfectant/cleaning agent that
is compatible with the materials.
ü
Unit care system, e.g. OroCup
❯
To pre-clean, suck up 2 litres of water with the
care system.
❯
Aspirate the disinfection/cleaning agent with
the care system.
11.3 Once or twice a week before
the midday break
Under harsher conditions (e.g. hard water
or frequent use of prophy powders) 1x
daily before the midday break
The following are required for cleaning:
ü
Special non-foaming detergent for suction
units that is compatible with the materials.
ü
Unit care system, e.g. OroCup
❯
To pre-clean, suck up 2 litres of water with the
care system.
❯
Aspirate the cleaning agent with the care sys-
tem.
❯
Rinse with ca. 2 l water after the application
time.
Usage
28 9000-606-79/30 1912V003
EN
To Next Page
Loading...
Need help?
General
