When it all lights, it indicates the
vehicle is in 4WD status, when
only the lower two wheel signal
lights, it means in 2WD status
5
LEFT/RIGHT Turning
Indicator
(
GREEN
)
Turn on left turning lights, is
flashing together with front and
rear left turning lights to remind
you that you can turn to the left.
Turn on right turning lights,
is flashing together with front
and rear right turning lights to
remind you that you can turn to
the right.
When emergency alarm switch
is “ON”,
I are flashing together
with turning lights to remind you
that you are in emergency case.
6
High Beam Indicator
(
GREEN
)
When switch is “HI”, is
in light to remind you that it is
in high beam.
CAUTION: Never use HBI during
normal operation.
■
2WD/4WD switch
（
only 4WD
）
2WD/4WD is controlled by
impulse motor. When the drive
shaft spline is not joggled in the
spline housing, the impulse motor
will keep on making signal to make
the motor work，till the drive shaft
spline is joggled in the spline
housing to finish the 2WD/4WD
switch. If the motor works more
than 24 times within one minute but
the drive shaft spline is still not
joggled in the spline housing it will
alarm ， in that case you should
operate it in the opposite way to protect
the motor in order to avoid overheat for
the motor to get burnt.
Note
when the switch cannot be
realized successfully, it will alarm, and
you should operate it in the opposite
way to protect the motor in order to
avoid overheat for the motor to get
burnt.
■
Front and rear differential lock shift
（
only 4WD
）
Lever forward means differential
unlocked, backward means locked
；
left
to control front and right for rear
Fuel Tank Cap
To Next Page
Loading...