EasyManua.ls Logo

Duruxx DRX2 - Brake Fluid

Duruxx DRX2
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
Brake Fluid
Recommended Fluid
Always use brake fluid meeting
the specification DOT 4 only.
CAUTION: To avoid serious
damage to the braking system,
do not use fluids other than the
recommended one, nor mix
different fluids for topping up.
Fluid Level
With vehicle on a level surface,
check brake fluid in reservoirs
for proper level. They should be
above MIN. mark. Add fluid as
required. Do not overfill.
Clean filler cap before
removing.
CAUTION: Use only DOT 4
brake fluid from a sealed
container. Do not use brake fluid
taken from old or already
opened containers.
NOTE: A low level may indicate
leaks or worn brake pads. See
an authorized Duruxx DRX2
dealer.
Brake cylinder Fluid Reservoir
Turn steering in the straight-
ahead position to ensure
reservoir is level.
Check the brake fluid level, the
reservoir is full when the fluid
reaches of the top of the reservoir.
NOTE: A cooling system that frequently
requires coolant is the indication of
leaks or engine problems. See an
authorized Duruxx DRX2 dealer.
Battery
This vehicle is equipped with a
12V36AH
battery.
Cleaning
Clean battery post with a wire
brush. Apply dielectric grease on
post to protect against oxidation.
Removal battery
Disconnect Green (-) cable first
then RED (+) cable.
Always
respect this order for
disassembly when removal
battery from vehicle; disconnect
Green (-) cable first.
Unscrew battery fix board, take out battery
Installation
Reinstall battery in vehicle.
Connect RED (+) cable first
then GREEN (-) cable. Always
connect RED (+) cable first.
Brake
cylinder