Valve Adjustment
See an authorized Duruxx DRX2 dealer for valves adjustment. Insufficient
clearance will cause loss of power and possibly damage the valves.
Excessive clearance will cause noise.
The muffler must be periodically purged of accumulated carbon.
Select a well-ventilated area, while remove the clean-out plug of the muffler,
make sure the muffler is cool.
Place the vehicle on PARK position.
1.
clean-out plug
2. Muffler
Block the end of the muffler with a shop rag and start engine. Momentarily
increase engine RPM several times to purge accumulated carbon out of the
muffler. Stop engine and allow muffler to cool.
Never run engine in an enclosed area. Never perform this operation
immediately after the engine has been run because exhaust system is very
hot. Make sure that there are no combustible materials in the area. Wear eye
protection and gloves. Never stand behind the vehicle while purging exhaust
system. Respect all applicable laws and regulations.
To Next Page
Loading...