EasyManua.ls Logo

Duruxx DRX2 - Page 69

Duruxx DRX2
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
69
NOTE: If vehicle is used in dusty area, inspect more frequently than
specified in MAINTENANCE CHART. If water/deposits are found, squeeze
and remove the clamp. Pull drain tube out.
CAUTION: Do not start engine when water is found in the drain tube.
When water/deposits are found, the air filter must be
inspected/dried/replaced depending on its condition.
Remove air filter as explained below.
Air Filter Removal
CAUTION: Never remove or modify any component in the air filter box.
Otherwise, engine performance degradation or damage can occur. The
engine carburetion is calibrated to operate specifically with these
components. Remove seat, release clamps and remove air filter box cover.
Pour cleaning solution into a bucket. Put the filter in to soak. While filter
soaks, clean inside the air box. Rinse the filter with warm water until all
cleaning solution disappears. Then, let the filter dry completely. When the
filter is dried, re-oil with air filter oil.
Air Filter Installation
Properly reinstall removed parts in the reverse order of their removal.
Electrical
Battery
WARNING
Never charge a battery while installed in vehicle.
Clean battery post with a wire brush. Apply dielectric grease on post to protect against
oxidation.
Fuses
If a fuse is damaged, replace it by one of the same rating.
CAUTION: Do not use a higher rated fuse as this can cause severe damage.
To remove fuse from holder, remove the fuse holder cover then pull fuse out.
Check if filament is melted.
Bulb Replacement
Always check light operation after replacement.
CAUTION: Never touch glass portion of a halogen bulb with bare fingers, it
shortens its operating life. If glass is touched, clean it with isopropyl alcohol
which will not leave a film on the bulb.