Adjustment
Shocks
WARNING
Left and right adjustment cams must always be set to the same position. Never
adjust one adjusting cam only. Uneven adjustment can cause poor handling
and loss of stability, which could lead to an accident.
Preload Adjustment
Adjust spring preload by turning adjusting cam accordingly, with the adjusting
wrench in vehicle tool box. Turn the adjusting cams clockwise for a firmer drive
and rough road condition or when carrying cargo or pulling a trailer. Turn the
adjusting cams counterclockwise for a light load and a smooth road condition.
Brake
Front and Rear Brakes
The front and rear brakes are hydraulic disc types. These brakes are
self-Adjusting and require no adjustment. The brake lever and the brake
pedal require no adjustment.
Check the following to keep the brakes in a good operating
condition:
– brake system for fluid leaks
– brake for spongy feel
– brake discs for excessive wear and surface condition
– brake pads for wear, damage or looseness.
Brake pads thickness
1
mm
Front discs thickness
10
mm
Rear disc thickness
10
mm
Maximum discs ware
0.5
mm
To Next Page
Loading...