your weight to the uphill side of the DRX2. Never attempt to turn the DRX2 around
on any hill until you have mastered the turning technique described further in this
Operator’s Guide on level ground. Avoid crossing the side of a steep hill if possible.
★Always use proper procedures if you stall or roll backwards when climbing a hill.
To avoid stalling, use proper gear and maintain a steady speed when climbing a hill.
If you stall or roll backwards, follow the special procedure for braking described
further in this Operator’s Guide. Dismount on the uphill side or to a side if pointed
straight uphill. Turn the DRX2 around and remount, following the procedure
described further in this Operator’s Guide.
★Always check for obstacles before operating in a new area. Never attempt to
operate over large obstacles, such as large rocks or fallen trees. Always follow
proper procedures when operating over obstacles as described further in this
Operator’s Guide.
★Always be careful when skidding or sliding. Learn to safely control skidding or
sliding by practicing at low speeds and on level, smooth terrain. On extremely
slippery surfaces, such as ice, go slowly and be very cautious in order to reduce the
chance of skidding out of control.
★Never operate a DRX2 in fast flowing water or in water deeper than that specified
further in this Operator’s Guide. Remember that wet brakes may have reduced
stopping ability. Test your brakes after leaving water. If necessary, apply them
several times for friction to dry out the pads.
★Always be sure there are no obstacles or people behind you when you operate
DRX2.
★When it is safe to proceed in reverse, go slowly.
★Always use the size and type tires specified further in this Operator’s Guide.
★Never modify a DRX2 through improper installation or use of accessories.
★Never exceed the stated load limits for a DRX2. Cargo should be properly
distributed and securely attached. Reduce speed and follow instructions in this
Operator’s Guide for carrying cargo or pulling a trailer. Allow greater distance for
braking.
To Next Page
Loading...