Duux Tag - Filling the Water Tank

1110
Adjusting the mist output Adjusting the bottom light
Using aromatherapy
1
Push the power button to turn the device on.
The power/water supply indicator will light blue
and it will begin to humidify with MIN (minimum)
mist output. The bottom light will lid up.
2
Push the mist button to change the mist
volume. The mist volume switches from MAX
(maximum) to MIN (minimum) and back, each
time the mist switch button is pushed. The
switched mist output display is lit. The mist
output will always be on MIN (minimum) when
the power is turned on, even if the mist output
was on MAX (maximum) before powering o.
Caution: Please take adequate care to prevent
excessive humidity. Wet oors from
condensation can form due to the room
environment and conditions of use. Please carefully
adjust or turn o the device.
1
Push the light button. The light will automatically
light up when the power is turned on. The light will
light up again when the power is turned on again,
even if it was previously switched o.
1
Remove water tank (see chapter 2 for detailed
instructions) and remove the water tank cap from the
water tank.
2
Pour your aromatic oil into the water tank.
Caution: Never not put anything other than water or
aromatic oils into the water tank.
Caution: Directly putting aromatic oil into a water tank
is a unique feature of the product. However, depending on
the aromatic oil you use, using this feature may stain the
water tank. Moreover, the perfume of the oils may remain
in the water tank. Please take this into consideration before
using aromatherapy.
Caution: Only use aromatic oils that are specially
designed to be used in ultrasonic humidiers.
3
Return the water tank to the device.
EN
DUU15045_Handleiding-TAG-Universeel.indd 10-11 14-04-17 15:46