Installation Details
Location
The water heater should be located as
close as possible to the most frequently
used hot water outlet. Adequate
access must be made for service to the
element(s), thermostat, relief valve and
anode. Ensure that the data plate and
associated warnings are clearly visible.
Note: All models are equipped with a
sacricial anode, accessible through the
top cover. Allow 50% of the height of
the water heater for clearance above to
replace the anode.
The product must be installed on a
at, solid supporting surface.
A properly drained overow tray must
be used where property damage could
occur from water spillage.
(See AS/NZS 3500.4 for further details.)
When installing this water heater in a
roof area as a mains pressure unit, refer to
local regulations.
Note: The warranty does not cover
damage due to leakage of the water
heater.
To Next Page
Loading...
