DVO Jade User Manual

Safety guidelines, essential tools, and materials needed for the damper service.

Remove hardware, clamp shock, and release air pressure from the bladder.

Loosen and remove the bladder components and then unthread the reservoir.

Remove the shaft and compression loader from the shock housing.

Clean the shock housing and compression loader with suspension cleaner.

Apply grease to the O-ring and re-install the compression loader into the shock housing.

Re-install reservoir, tighten, fill with oil, and cycle bladder to circulate oil.

Insert shaft, check oil levels, and install housing and bladder end caps.

Measure shaft depth, adjust bumper, and re-inflate bladder to correct pressure.

Secure reservoir cap, tighten valve core, and install air cap.

Clean the entire shock assembly and confirm readiness for riding.