- 56 -
For Tuning
MFJ HF/VHF Antenna/SWR/RF Analyzer w/ LCD, Counter & Meters - MFJ-259B
The MFJ-259B RF analyzer is a compact battery powered RF impedance analyzer. This unit
combines four basic circuits; a 1.8-170 MHz variable frequency oscillator, a frequency counter,
a 50 ohm RF bridge, and an eight-bit micro-controller. This unit makes a wide variety of useful
antenna or impedance measurements, including coaxial cable loss and distance to an open or
short. Primarily designed for analyzing 50 ohm antenna and transmission line systems, the
MFJ-259B also measures RF impedances between a few ohms and several hundred ohms. It
also functions as a signal source and frequency counter. The frequency range of impedance
measurement is 1.8 to 170 MHz, in six overlapping bands. Requires 10 AA size batteries for
portable operation (not furnished).
MFJ 12 VDC 500 mA AC Adapter w/ 2.1 mm Plug - MFJ-1312D
The MFJ-1312D is a 12 Vdc 500 ma AC Adapter with a 2.1 mm jack.
MFJ Carrying Pouch w/ Window for MFJ-209/MFJ-249/MFJ-259B - MFJ-29C
Tote your MFJ-259B anywhere with this genuine MFJ custom carrying case. Has back
pocket with security cover for carrying dip coils adaptors and accessories. Made of special
foam-filled fabric, the MFJ-29C cushions blow, deflects scrapes, and protects knobs, meters
and displays from harm.
Has a clear protective window for frequency display and cutouts for knobs and connectors --
use your MFJ SWR Analyzer without taking it out of your case.
Additional Accessories for your Hustler BTV 56
Additional Accessories for Your Hustler BTV
DX Engineering is proud to offer a comprehensive set of products specifically designed for an easy,
safe and productive quarter-wave HF vertical antenna installation. We are certain that you will be
pleased with your operating results from your properly planned and DX Engineering equipped
Hustler BTV antenna project.
DXE-RADP-3 - Radial Plate, Stainless Steel w/20 sets Radial Attach Hardware, up to 3" pipe
Unique enough to be covered by two US Patents, the DX Engineering Radial Plate is meant for those of you that have or are building
a quarter wave vertical antenna and who want an easy, neat and effective way to connect those essential radial
wires and the coax to your vertical antenna for the lowest takeoff angle and strongest signals. Stainless steel
construction assures that your signal won't disappear like a disintegrating aluminum radial plate.
This plate will work perfectly with most commercially available vertical antennas such as the Hustler BTV series
(4BTV thru the 6BTV), the SteppIR (BiggIR or SmallIR) or one of your own construction.
Radial Plate is made of 304 Stainless Steel, .125 inch thick, 12" x 12" outside dimensions. The use of an anti-seize
compound such as Never-Seez must be used with any Stainless Steel hardware to prevent galling.
To Next Page
