dye M3s - HYPER6 S PRO GAS THRU REGULATOR; BASIC VELOCITY ADJUSTMENT; ADJUSTMENTS

18
WWW.DYEPAINTBALL.COM
1. 007 UR90 o-ring
2. 014 BN70 o-ring
3. Reg body
4. Attachment screw
5. Piston
6. Main spring
7. 015BN70 o-ring (3 pieces)
8. Cartridge top cap
BASIC VELOCITY ADJUSTMENT
ADJUSTMENTS
The Hyper6s regulator controls your velocity.
It is pre-set at approximately 115 psi. This will enable your gun to shoot about 285 FPS. The
M3s’s velocity will be affected by paint size, weather conditions, altitude and other factors.
To adjust your velocity use a 3/16” Allen wrench and insert it into the bottom of the fore grip
where the Hyper6s reg is located.
To lower the velocity turn the Allen wrench clockwise (inward),
this will decrease the pressure.
To raise the velocity turn the Allen wrench counter clockwise (outward)
this will increase the pressure.
Each 1/3 turn will change the Hyper6s reg output Pressure by approximately 15PSI.
The M3s is equipped with an internal pressure sensor for the Hyper6s. You are able to view
your Hyper6s reg pressure at any time on the OLED screen. The Pressure readings can be
viewed by entering into the Data Settings Menu and scrolling to the Pressure Gauge Screen
(see page 7), or while in the Playing Screen you can press the joystick left and the Systems
Check screen will appear for 10 seconds and display your M3s’s PSI reading, along with other
information about the M3s’s operating system (see page 4).
HYPER6S PRO
™
GAS THRU REGULATOR
• THE HYPER6S™ CAN HOLD A SMALL RESIDUAL CHARGE OF GAS, TYPICALLY 1 SHOT.
ALWAYS DISCHARGE THE MARKER IN A SAFE DIRECTION TO RELIEVE THIS RESIDUAL
GAS PRESSURE.
• EXCESSIVE DIRT AND DEBRIS CAN AFFECT THE HYPER6S™’S PERFORMANCE AND
INCREASE THE NEED FOR SERVICE.
2
3
4
5
6
7 7
7
8
9
11
10
12
13
15
16
17
14
1
9. Cartridge body
10. 008UR90 o-ring
11. Seat retainer
12. Purging reg seat
13. Check valve
14. Check valve spring
15. Adjustment screw
16. 010BN70 o-ring
17. Rubber retaining ring
HYPER
6S PRO COMPONENT LIST