WWW.DYEPAINTBALL.COM
PROBLEMS WITH ELECTRONICS
M3S WON’T TURN ON
• Make sure battery is well charged. Marker shooting slow
when eye is on and blinking green
• The eyes are not working correctly. Clean the eyes.
You’ll know that they are clean if the LED turns red when
there is nothing inside the breech of the M3s.
• Make sure the eye wires are not broken or pinched.
• The battery may be low. In this case, the battery should
be charged as soon as possible.
MARKER SHOOTING SLOW WHEN EYE IS ON AND
BLINKING GREEN
• The eyes are not working correctly. Clean the eyes.
You’ll know that they are clean if the LED turns red
when there is nothing inside the breech of the M3s.
• Make sure the eye wires are not broken or pinched.
• The battery may be low. In this case, the battery
should be charged as soon as possible.
SOLENOID WILL NOT ACTIVATE / TRIGGER NOT
WORKING
• Check that the trigger adjustment is not set so that the
micro switch cannot activate. You should hear a small
click when pulling the trigger.
• If the M3s fires once when turned on but not after that,
your trigger is set so that the micro switch is always
activated. Re-adjust the trigger.
• Check that the solenoid cable is attached to the board
and to the correct connector (solenoid should be
attached to the two-prong connector).
• Check the Dwell is set correctly (see page 5).
TRIGGER BOUNCE / M3S SHOOTING MORE THAN
ONE BALL PER PULL IN SEMI-AUTOMATIC MODE
• Raise the trigger sensitivity level in the configuration
mode.
• Check that the trigger is not adjusted too short.
ERRATIC VELOCITY / M3S WON’T FIRE
M3S FIRES BUT BALLS ARE DROPPING OFF OR NOT
EVEN COMING OUT OF THE BARREL
• Make sure the battery is charged.
• Maintain the factory dwell setting of 16.
• Make sure bolt is well lubed and moves well. If there is
too much friction in the bolt it will cause the M3s to shoot
down. Replace O-rings causing this excess friction.
• Make sure air system is screwed in all the way.
• Make sure Hyper6s ™ is set correctly.
FIRST SHOT IS TOO HIGH
• Change the seat inside the Hyper6s™ Regulator.
For disassembly instructions consult page 18 in
the technical section.
• Check that the 011 and 012 O-rings on the valve tube,
as well as the 016 on the inside of the top hat are in
good condition.
• Try turning off the ABS feature.
VELOCITY IS NOT CONSISTENT
• Make sure the paintballs you are using fit the barrel well
and are consistent in size and shape.
• Remove the bolt kit and re-lube it. Change any O-rings
causing a lot of friction. Make sure 014 O-ring in bolt tip is
in place and in good condition.
• Ensure the spring behind the valve is in place and that
the 016 O-ring at the back of the valve tube is in place and
in good condition.
• Check that the Hyper6s™ regulator is working correctly
and that the pressure is consistent.
• Disassemble and change worn out O-rings and the
regulator seat in the Hyper6s™ regulator.
TROUBLE SHOOTING GUIDE
24
To Next Page
Loading...