2
Installing the Software
This section describes how to install the CardScan Image Capture software.
Depending on your system, you may be asked to restart your computer at
the end of the installation.
NOTE To install the CardScan Image Capture software, you must
be logged in as Administrator.
To install the software
1 Close any open applications.
2 Insert the CardScan Image Capture CD
into your DVD drive. After a few seconds,
the installation screen appears.
If the installation screen does not appear,
do the following:
a. On the Windows taskbar, click Start and then choose Run. The Run
dialog box appears.
b. Enter D:\setup.exe (where D is the letter assigned to the DVD drive),
and then click OK.
3 When prompted, enter the product key located on the DVD
sleeve, and then click Continue to complete the installation.
NOTE If you choose not to enter the product key at this time, you will
begin a 30-day trial period.
4 Select Complete to install the entire application, or select Custom to
install specific program features.
To Next Page
Loading...
