Dymo LabelManager 210D+ User Manual

5
LabelManager
®
210D+
User Guide
About Your New Label Maker
With the DYMO
®
LabelManager 210D
+
electronic label maker, you can create a
wide variety of high-quality, self-adhesive labels. You can choose to print your
labels in many different font sizes and styles. The label maker uses DYMO D1 label
cassettes in widths of 1/4” (6 mm), 3/8” (9 mm), or 1/2” (12 mm). These label
cassettes are available in a wide range of colors.
Visit www.dymo.com for information on obtaining labels and accessories for your
label maker.
Product Registration
Visit www.dymo.com/register to register your label maker online. During the
registration process, you will need the serial number, which is located inside the
back cover of the label maker
Getting Started
Follow the instructions in this section to print your first label.
Connecting the Power
The label maker is powered by standard batteries or an AC power adapter. To
save power, the label maker automatically turns off after two minutes of inactivity.
Inserting the Batteries
The label maker uses six high-capacity AA alkaline batteries.
To insert the batteries
1 Slide the battery compartment cover away from the
label maker. See Figure 2.
2 Insert the batteries following the polarity markings (+
and –).
3 Replace the cover.
Remove the batteries if the label maker will not be used
for a long period of time.
Safety Precautions
 Do not mix old and new batteries.
 Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,
etc.) batteries.
 Remove the batteries if the printer will not be used for a long period of time.
Figure 2

Dymo LabelManager 210D+ Specifications

General

Printing Technology	Thermal Transfer
Display	LCD
Resolution	180 dpi
Power Source	AC adapter
Label Width	6 mm, 9 mm, 12 mm
Font Styles	Bold, Italic, Outline, Shadow, Underline
Tape Width	6 mm, 9 mm, 12 mm