14
Clean your labelmaker from time to time to keep it
working properly. Clean the cutter blade each time
you replace the label cassette.
To clean the cutter blade
1. Press
A
to turn off the power.
2. Press
A
and together. The message,
Cut Test, appears on the display.
3. Press and hold the + keys. The cutter
blade will move into view in small steps.
4. When you are able to access both sides of the
blade, release the keys.
5. Use a cotton ball and alcohol to clean both sides
of the cutter blade.
6. After cleaning the blade, press to return
the blade to its home position.
You can also follow this procedure if the
cutter blade becomes lodged in the forward
position and will not move.
To clean the print head
♦ Clean the print head using the cleaning tool
located inside the label compartment lid. See
Figure 11.
Figure 11
Shift
To Next Page
Loading...
Need help?
General
