Dyna-Glo DGPH402SS - Assembly Instructions; Wheel Assembly and Ignitor Setup

7
ASSEMBLY INSTRUCTIONS
1. Attach the two wheel assemblies (Q) to the
bottom plate (R) with eight M6 x 12 mm bolts
(DD) as illustrated. Tighten with the Phillips
screwdriver (OO).
2. Unscrew ignitor knob (marked with a lighting
bolt) on the control box assembly (I). Insert
the AA battery (NN) with positive end (+)
outward and replace the ignitor knob.
Bolt M6 x 12 mm
Hardware Used
Hardware Used
Phillips
Screwdriver
AA battery
x 8
x 1
DD
NN
Q
I
DD
OO
NN
1
2
The electronic ignition requires 1 “AA” alkaline battery, which is included.
WARNING
DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (Carbon-Zinc), or rechargable (Nickel-Cadmium) batteries.
DO NOT dispose of batteries in re. Improper disposal may cause batteries to leak or explode.
R