Dyna-Glo DGPH101BR - User Manual

Questions and Answers

S
Stephen WhiteAug 10, 2025
How to fix Dyna-Glo DGPH101BR Patio Heater when pilot won’t light?
- T
  Trevor MacdonaldAug 10, 2025
  If the pilot light on your Dyna-Glo Patio Heater won't light, there are several possible reasons: * The cylinder valve may be closed. In this case, open the valve. * There may be a blockage in the orifice or pilot tube. If so, clean or replace the orifice or pilot tube. * There might be air in the gas line. To resolve this, open the gas line and bleed it by pressing the control knob in for no more than 1-2 minutes, or until you smell gas. * Low gas pressure can also be the culprit. Turn the cylinder valve OFF and replace the cylinder. * Finally, the igniter itself may have failed. Use a match to light the pilot and obtain a new igniter for replacement.
W
wanda38Aug 16, 2025
What to do if the pilot won’t stay lit on Dyna-Glo Patio Heater?
- M
  Mr. Robert Day MDAug 16, 2025
  If the pilot light on your Dyna-Glo Patio Heater won't stay lit, consider these potential causes: * Dirt buildup: Clean any dirt from around the pilot. * Loose connection: Tighten the connection between the gas valve and pilot assembly, and then perform a leak check. * Faulty thermocouple: Replace the thermocouple.
H
Herbert TorresAug 22, 2025
Why won’t the burner light on my Dyna-Glo DGPH101BR?
- S
  Stephen BishopAug 22, 2025
  If the burner on your Dyna-Glo Patio Heater won’t light, consider the following potential causes: * Propane cylinder is frosted over: Wait until the propane cylinder warms up and becomes unfrosted. * Blockage in orifice: Clear any blockage in the orifice. * Control knob position: Turn the control knob to the ON position.
K
kwrightAug 27, 2025
Why is the burner flame low on my Dyna-Glo DGPH101BR Patio Heater?
- C
  Casey WagnerAug 27, 2025
  If the burner flame on your Dyna-Glo Patio Heater is low, it could be due to several reasons: * Low gas pressure: Turn the cylinder valve OFF and replace the cylinder. * Outdoor temperature: If the outdoor temperature is less than 40ºF (4ºC) and the tank is less than 1/4 full, use a full cylinder. * Blockage: Check the burner and orifices for any blockage.
C
christopher40Sep 2, 2025
What causes carbon build-up and black smoke from Dyna-Glo DGPH101BR Patio Heater?
- S
  Shannon PatelSep 2, 2025
  Thick black smoke or carbon buildup on your Dyna-Glo Patio Heater can be caused by: * Dirt or film: Clean the reflector and flame screen. * Blockage in burner: Remove any blockage and clean the burner inside and outside.