Inputs
DYNACO USA, INC, 11 The Leader in Door Safety & Design
Input 7: Typically used for the open button on a three position switch.
Input will strictly open the door when activated.
Input 8: Typically used for the close button on a three position switch.
Input will strictly close the door when activated.
Input 9: Used for emergency stop or to stop door from being activated. Also
can be wired as the stop button in a three position switch.
Input 10: Used by DYNACO USA Inc. for optional operations ordered with
Dynaco door.
Remote E-stop
N/C Contact
(Jumper)
24 VAC +
1
24 VAC +
1
24 VAC +
1
24 VAC +
1
24 VAC +
1
24 VAC -
X2
24 VAC -
X2
Input 2
2
Input 2
2
Input 3
3
Input 4
4
Input 7
7
Input 8
8
Input 9
9
Input 9
9
Pull cord / push button
N/O contact
Motion sensor / Loop
N/O Contact
Reversing Edge
N/O Contact
Open
N/O Contact
Close
N/O Contact
Stop
N/C Contact
Figure 5.0-2: Basic Input Wiring
To Previous Page
Loading...