DYNACO Dynalogix II - Setting Door Limits; Initial Power-Up Limit Setup

2.0 Setting Limits on Initial Power-up
Automatic activation's should be disconnected prior to setting limits. If connected
door may activate and injury or damage may occur.
!
CAUTION
1. On initial power up the DY4000 will blink SET LIMITS on the display.
2. Press and hold both PROGRAM buttons until display changes to Password.
After display changes, release buttons. See figure: 2.0-1.
4. Press and release the Enter button. Display should change to: LimitSet.
See figure 2.0-2.
Setting Limits
DYNACO USA, INC, 3 The Leader in Door Safety & Design
Confirm all electrical connections are properly wired and terminated before power up.
Reference: Wiring Diagram that came with DYNACO Door.
3. Press and release the red arrow buttons to scroll to 562.
Note: Password number will be stored for 4 minutes after initially entering.
Entering program mode during this time will not require reentry of
password number.
Figure 2.0-1: Entering Program Mode
JOG
UP/RESET
JOG
DOWN
OPEN CLOSE
MC/PB AC/LOOP
PROGRAM
CLOSE
TIMERS
RUN
TIMERS
MENU
ENTER
Press and
hold
PROGRAM
button until
display
changes to:
MESSAGE DISPLAY / COUNTER
Password
0
Figure 2.0-2: Enter Button
JOG
UP/RESET
JOG
DOWN
OPEN CLOSE
MC/PB AC/LOOP
PROGRAM
CLOSE
TIMERS
RUN
TIMERS
MENU
ENTER
Press and
release the
Enter button.
Display
should
change to:
MESSAGE DISPLAY / COUNTER
LimitSet
STOP
Note: On initial start up the Password screen will be bypassed, and will
directly enter the LimitSet screen.