Dynacraft 8802-33 User Manual

11
Attaching the Number Plate
Tools required: Philips screw driver
1 Remove the three screws from the accessory kit. Align the number plate with the
two holes in the front fork as shown and tighten them with a Phillips screw driver.
2 Align the hole on back of the number plate with the hole on the front fork as
shown, and tighten it securely with a Phillips screw driver.

Dynacraft 8802-33 Specifications

General

Brand	Dynacraft
Model	8802-33
Category	Bicycle
Language	English