18
3. With a 10mm wrench, loosen the
brake cable anchor and disconnect the
cable.
Note: Get all the anchor hardware out
of the brake arm hole and keep them
together to avoid losing any parts.
4. Use two 15mm wrenches, to loosen
the axle locknuts. (Remove axle locknuts
and safety retainer washers from axle
and keep them together to avoid losing
them).
5. Press the chain tensioner down with
your hand so as to get the chain off. Then
slide and remove the wheel. (Replace
with a new chain, new rear brake or new
rear wheel if needed at this time).
To Next Page
