Dynacraft BALANCE CYCLE User Manual

8
REAR WHEEL INSTALLATION
STEP 1. Loosen axle nuts on rear wheel axle with fingers so that nuts are still
attached to axle.
STEP 2. Guide rear wheel into rear fork slots, position axle in rear fork slots,
make sure washers and nuts are positioned outside of rear fork legs
(see Figure 10).
NOTE: Safety tabs should be
locked into safety locking holes
(see Figure 10).
STEP 3. Tighten wheel nuts on left and right side of rear wheel axle securely.
NOTE: When tightening, be sure the rear wheel is centered in the frame.
FIGURE 10 FIGURE 11
AXLE NUT SAFETY LOCKTAB
WASHER
SAFETY
LOCKING HOLE

Dynacraft BALANCE CYCLE Specifications

General

Brand	Dynacraft
Model	BALANCE CYCLE
Category	Bicycle
Language	English